![]() ![]() Long ago expired and I am not prepared to purchase a copy of the Unfortunately, I can't offer any informedĪdvice regarding HRD setup/configuration. Interfering, try temporarily disabling it.Īnother possibility is that something is incorrectly configured Your running HRDLogbook elevated, turn that off, there should beĪlso a possibility is your Virus/Malware protection could be Running HRDLogbook elevated with Run as Administrator set). That error dialog shows there was no TCP response from theĪs to the cause, it could be a privileges mismatch (if your That there is something to be set within HRD but I am not able to When I go to log a FT8 QSO, it does not get logged and an errorīox is displayed. ![]() JTAlertX v2.12.7 set to log to the appropriate log within HRD. ![]() Working, slowly, toward migrating to HRD as my logger. You cannot use the Scan Log to automate the updates of the various To run JTAlert as the B4 checks will be out totally of sync and Logger) and rely of WSJT-X adif broadcast, then there is no need If you choose to not enable HRD logging (or any other JTAlert It communicates with HRD over the official HRD TCP Regarding HRD Logging, the better option is to enable HRD logging ![]() QSO data with the minimal WSJT-X logged data. JTAlert will combine the results of an XML lookup and previous Log Of the original JTAlert LastQSO UDP broadcast, even down to the That should do it! And make sure you're running the latestįWIW, The WSJT-X N1MM adif broadcast is a copy Under the N1MM + Broadcast section, check "enable logged contact Select Merge for "My Station Fields Should Be" Target Database should be set to whatever you call your logbook. Logbook - Go to Tools - Configure - QSO Forwarding.Ĭheck "Fill In Missing Fields On Receive"Ĭheck the checkbox next to "Receive QSO Notifications using UDP ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |